Low Profile Steering Cylinder Clamps (Steel Base)

Low Profile Steering Cylinder Clamps (Steel Base)Got a hardcore trail rig, Ultra4 car, trophy truck, or rock crawler with full hydraulic steering? Keep that hydraulic cylinder in its place! These are the straight BEEF clamps when it comes to retaining your hydraulic cylinder! Billet hydraulic steering cylinder clamps for mounting full hydraulic rams to your axle or chassis. Bottom is 1018 steel with 5 8" bolt threads and the top is billet 6061 aerospace aluminum. Intended to be welded directly to

Got a hardcore trail rig, Ultra4 car, trophy truck, or rock crawler with full hydraulic steering? Keep that hydraulic cylinder in its place! These are the straight BEEF clamps when it comes to retaining your hydraulic cylinder!

Billet hydraulic steering cylinder clamps for mounting full hydraulic rams to your axle or chassis. Bottom is 1018 steel with 5/8" bolt threads and the top is billet 6061 aerospace aluminum.

Intended to be welded directly to your axle housing or chassis, giving you the STRONGEST hydraulic steering mounts in the industry. Designed to retain the steering cylinder ends to prevent catastrophic failure from the ram sliding side to side, as well as, keeping the threaded end caps from backing out and blowing out the internals all over the trail. Keep your rig on the trail or in the race!

• Sized for 2.5" (SC2212, SC2213, & SC2218), 2.75" (SC2227), and 3.0" (SC2217, SC2228) hydraulic steering rams 
• Top clamp made from 6061 billet aluminum anodized clear
• Threaded lower weld block made from 1018 steel
• 1"+ shorter than standard 3 piece clamp designs (mounts ram closer to surface)
• 12-point, 170 KSI, 5/8"-16 hardware (Better than grade 8)
• Sold as sets of 2 outers, 2 inners, or all 4 clamps (4 clamps recommended for racing)

Please verify your steering ram size before ordering. The size listed is based on internal bore size. External steering cylinder diameter for the

-2.5" ram OD = 2.875"

-2.75" ram OD = 3.145"

-3.0" ram OD = 3.345" 

***For off-road use only***

Torque 12-point bolts to 50 ft-lbs with blue thread locker.

Please e-mail us [email protected] if you have any special requests or a setup that is different than this. Also, take a look at our standard end retaining Steering Cylinder Clamps.