Hardrace Super Tie Rod Ends - 00-09 S2000

Hardrace Super Tie Rod Ends - 00-09 S2000Hardrace's new Super Tie Rods for the Honda S2000 chassis have pillowball (spherical bearing) ends. They are built for full durability and increased steering response while minimizing bumpsteer when used in conjunction with roll center adjusters (aka extended lower ball joints). The tie rod ends contain pillowballs (spherical bearings) that eliminate the factory bushing allowing increased durability and greater feedback. Used in conjunction with roll

Hardrace's new Super Tie Rods for the Honda S2000 chassis have pillowball (spherical bearing) ends. They are built for full durability and increased steering response while minimizing bumpsteer when used in conjunction with roll center adjusters (aka extended lower ball joints). 

The tie rod ends contain pillowballs (spherical bearings) that eliminate the factory bushing allowing increased durability and greater feedback. Used in conjunction with roll center adjusters (aka extended lower ball joints), you will have the ultimate steering input with minimal bump steer in your S2000 during road racing duties.

NOTE: HR Super Tie Rod ends mount upside down to the knuckle assembly as opposed to right side up (like OEM). This helps correct tie rod geometry on lowered S2000's by keeping them horizontally straight and parallel to the front lower control arms rather than angled upwards when the weight of the car is on the ground.

Hardrace S2000 front & rear roll center adjusters along with front & rear bump steer kit is HIGHLY recommended to be used in conjunction with these super tie rods for the ultimate in S2000 handling.

** This item is for race track use only, not suitable for street use.